Air Deflector
Prototype in MDF
 IMG_0565 |
 IMG_0566 |
Now in plastic
 IMG_0560 |
 IMG_0561 |
 IMG_0562 |
 IMG_0567 |
 IMG_0568 |
 IMG_0569 |
Dust collector
This will cut out everything I need for the dust collectorAnd enough for my first test at the quick change dust sheild
Later I cut out a couple of more dust shield so that I can have different length shirts for short and very long cutters
 IMG_0553 |
The basic off the holding part.
 IMG_0558 |
Everything Assembled
 IMG_0570 |
 IMG_0571 |
Put the plate under the cutter
 IMG_0572 |
Slide it in the slot
 IMG_0573 |
 IMG_0574 |
Put an end clamp on it
Note: this was cut by hand after all the initial parts came out of the cnc cut out
 IMG_0575 |
 IMG_0576 |
Just drop the bolts in the holes
 IMG_0577 |
Ready to go
Honestly it might take me 5 at worst 10 seconds to take it off or onReally effortless and appears to be working like a charm
 IMG_0578 |
Getting ready for another skirt
 IMG_0579 |
Adjustment to hold the vacuum hose
 IMG_0635 |
 IMG_0637 |
 IMG_0639 |
Plans for Dust Collector and Air Deflector
Note the side walls for the hose are not included in the plans cut these on the table saw|
|